JOHN DEERE - 360 Back
JOHN DEERE - 360 FLAIL MOWER
SHRED YOUR TOUGHEST CROP RESIDUE IN A SINGLE PASS
Whether youre looking to maintain your pasture, shred stalks, or mow along roadsides, parks and school grounds, John Deere has a long line of heavy-duty cutting equipment ready to meet your needs. It all starts with flail fastening system which eliminates clogging from mud or crop residue. Its bracket design also help prevent knife and ring loss.
In-field productivity is also enhanced with the all-new re-cutterbar. Its design creates a strong vacuum that forces re-cutting of crop residues. And the main cutter features 248 knives mounted the full length of the rotors. So, you wont miss a stalk.
For long-lasting performance in the toughest mowing environments, look to the 300 Series Flail Mowers. Cutting widths range from 4 feet, 10 inches to 7 feet, 6 inches. The largest model also comes in an offset design for cutting close to trees in orchards, and for added reach when mowing along roadside shoulders. Heat-treated, side-slicer knives rip into grass, weeds, and light brush at 95 mph tip speed. Heavy-duty gearcases have a continuous 65-horsepower rating to withstand punishing workloads. And theyre warranted for a full two years. On the outside, tough 3/16-inch-thick hoods resist wear and dents caused by fast flowing debris.
HEAVY-DUTY GEARBOX AND DRIVE SHAFT
All John Deere flail mowers feature this rugged, heavy-duty gearbox with a continuous 65-hp rating and an intermittent 90-hp rating. Another feature included is a five-year, unlimited-hour warranty.
BASE EQUIPMENT SIDE-SLICER KNIVES OR OPTIONAL SMOOTH-CUT KNIVES AVAILABLE
They provide aggressive cutting action in tough conditions. The side-slicer knife characteristics are as follows: Knives are made of heat-treated alloy steel for durability, Individual knife weight, along with the centrifugal force created, provides an aggressive cutting action and edges are ground to provide a sharp cutting surface and reduced horsepower requirements.
HEAVY-DUTY HOOD AND END PLATES
Hood is made of 0.48 cm (0.188 in) thick steel to resist denting and wear, End plates are made of 0.64 cm (0.250 in) thick steel to provide structural support and resistance to side thrusts and full-length torque tube helps prevent twisting when operating on uneven ground.
All machines have a Category 2/1 3-poing hitch. Bushings or reversible pins are included for Category 2/1 compatibility.
Similar models may be shown in addition to the featured model. Equipment may be shown with options.
Specifications are subject to change without prior notice.
Express Financing Get Pre-Approved
Get a FR8Star Shipping Estimate